Interfacial geochemistry of barium in suspension and sediment from Zhujiang Estuary

Chemical forms of Ba are determined in samples of suspension and sediment from the Zhujiang Estuary. Their interfacial geochemical processes are discussed. Total suspended Ba content is between 2. 4 and 40. 4 μg/L, and mostly exists in the crystalline form (43. 5%), secondly in the Fe-Mn oxidative form (23.1%). Percentages of organic, carbonate and exchangeable forms are 14. 8%, 11. l%and 7.4%, respectively. Total content of Ba in the sediment is between 158. 6 and 48. 0 ug/g. Percentages of crystalline form, Fe-Mn oxidative form and carbonate form are 78. 4% ,13. 5%and 8. 2%, respectively. Organic and exchangeable forms are not detected. The study on the mechanism of interfacial movement suggests that the salinity range of 10 is the turning point for the varied distribution of Ba. The subsidence of crystalline form affects the decrease of Ba content in suspension. The decrease mostly takes place in the salinity range lower than 10, which corresponds to the high value of Ba content in the sediment. The     

优选沙子口污水处理厂排海口位置的研究

对青岛沙子口污水处理厂排海口位置进行了水动力条件、混合区域海水交换率及更新周期、污染物扩散系数及浓度分布、水质点迁移轨迹的比较，确定了其最佳排海口位置方案。     

水动力条件差异导致潮坪分形特征变化实例研究

研究区位于1964～1976年黄河由刁口流路入海时形成的三角洲潮坪.为进行石油开采在潮坪上构筑的交通设施对波浪形成了良好的屏障,水动力条件具有显著差异的屏障两侧潮坪是研究潮坪特征对水动力条件响应的天然实验场所.在屏障两侧各选择一典型区,实测地貌形态,取样品进行粒度成分分析,根据实测资料分析确定潮坪分形特征.发现水动力环境的强弱决定着潮坪的形貌、沉积物粒度分维值的变化规律.水动力环境强的一侧潮坪滩面分维值高,且随着初始计算网格宽度增大迅速降维;表层沉积物粒度分维值小,且离散性大.相反,在另一侧潮坪滩面分维值低,且随着初始计算网格宽度增大分维值无显著变化;表层沉积物粒度分维值高,且具有较好的一致性.当初始计算网格宽度增大到某个值时,两侧潮坪形貌分维值渐趋一致.在屏障两侧各沿一条与屏障大角度相交的测线取样,并各选择一点采取不同深度的样品做分析计算,发现在水动力条件弱的一侧,样品的粒度分维值表现为远离屏障逐步降维、随深度增加分维值增大的规律;相反一侧粒度分维值变化的规律性很不明显.讨论了水动力环境对潮坪分形特征影响机理.     

海洋生态环境监测的指标体系研究

本文在总结国内外各种海洋生态监测方法的基础上,构建生物分布指数、生物暴露指数和生物反应指数,并由此确定生态质量总指教。生态质量总指数可以综合反映特定海洋环境的生物群落特征,典型污染物在生物体内的蓄积特征以及生物体对环境污染的生理生化反应特征,因此可以应用于近岸海洋环境质量的生态监测。     

黄、渤海无机氮的收支模式初探

根据黄、渤海无机氮的收支状况，首次提出了黄、渤海无机氮的稳态收支模式。模式研究结果表明，大气沉降、陆源输入和海底输入的无机氮通量分别占黄、渤海无机氮浮游植物总需求量的3%、4%和12%。无机氮的外部输入约占总需求量的1/5，其他部分则由水柱中的内部再循环（再生）供给。     

A note on the effects of a thin visco-elastic mud layer on small amplitude water-wave propagation

In this note we investigated the effects of a thin visco-elastic mud layer on wave propagation. Within the framework of linear water-wave theory, analytical solutions are obtained for damping rate, dispersion relation between wave frequency and wave number, and velocity components in the water column and mud layer. The wave attenuation rate reaches a maximum value when the mud layer thickness is about the same as the mud boundary layer thickness. Heavier mud has a weaker effect on the wave damping. However, the wave attenuation rate does not always decrease as the elastic shear modulus increases. In the range of small values for elastic shear modulus, the wave attenuation can be amplified quite significantly. The current solutions are compared with experimental data with different wave conditions and mud properties. In general, good agreements are observed.     

曲流点坝薄夹层构形对驱油效率及剩余油形成与分布的影响

陆相储层单砂体内的薄夹层是形成储层流体流动非均质的主要因素之一,单砂体内部薄夹层极薄、规模小、测井全部识别有一定困难,且位于层内。在油田开发初、中期作用不明显,而在高含水期、三采阶段,单砂体及其渗透率宏观分布已不能详尽揭示层内剩余油分布,层内薄夹层对注入剂驱油的影响及其重要性逐渐显现出来,与渗透率在储层内韵律性分布有同等重要的地位,也是储层精细表征的重要内容。以往只是着重从渗透率在储层内分布的不均衡的角度来研究储层中驱油效率问题,忽略了薄夹层的对储层驱油效率的影响。以大庆油田葡萄花油层组PⅠ2小层曲流河道砂体为例,对曲流河道砂体内部薄夹层构形对驱油效率及剩余油的形成与分布作了初步的分析和探讨。在排除开发因素差异的同井单砂体分析条件下,提出了“单砂体内部薄夹层空间构形 渗透率垂向序列 重力”三因素共同控制剩余油分布、驱油效率多段垂向序列模式。     

基于仿射变换的数字影像内定向的误差控制分析

数字化摄影测量生产中的误差来源众多,尤其是系统误差常常很突出。针对这个问题,首先深入分析了附有未知数的仿射变换控制模型参数的误差估计,然后利用误差传播定律和误差综合原理,推导出了任意非检控点经仿射变换后输出数据精度的计算公式,并通过数值分析从理论上验证了用四个角框标进行数字影像内定向是最佳误差控制方案。     

A low level supplementary heating system for free divers

A simple and effective method of heating divers in extreme cold water has been developed. The local heating concept utilizes a uniformly distributed granular mixture of magnesium and iron particles packed in small sachets. Upon activation by sea water, the two metal mixture behaves as a multitude of short-circuited electrolytic cells, producing thermal energy rather than electrical energy. The 45 mm-square sachets may be placed where heating is required on the diver's body, thus giving rise to the term “local heating”, obviously, the heating system requires no pumping device, or distribution network. Heating rate and duration of output of the sachets are controlled by particle size, and mixture ratio of the constituent Mg and Fe particles.This paper described the development, testing and performance of the heating sachets. Results of live tests in different dive situations are also presented and discussed.